Knob and tube replacement
Live knob and tube circuits traced, disconnected, and replaced with new grounded wiring.
Electrical service
Knob and tube and aluminum wiring replaced in older Etobicoke and Toronto homes, with the permit, inspection, and paperwork your insurance company asks for.
Knob & Tube Replacement
Many Etobicoke and Toronto houses built before the 1950s still have some live knob and tube wiring, and homes built from the mid-1960s to the late 1970s may have aluminum branch wiring. Many insurance companies ask about both, and some will not insure a home until the old wiring is replaced or inspected.
Croatian Electric first finds out how much of the old wiring is still in use, then plans the replacement room by room. New wiring is fished through the existing walls and ceilings wherever possible, so most of the job needs small access holes instead of opened-up walls.
Included work
The exact scope depends on the home, panel, wiring access, finished surfaces, and electrical issue being reviewed.
Live knob and tube circuits traced, disconnected, and replaced with new grounded wiring.
Aluminum branch circuits replaced, or their connections repaired with connectors approved for aluminum where that fits the home better.
The ESA notification is filed and the work is inspected, so you have the documentation your insurance company asks for.
Old fuse panels and small services upgraded when the new wiring adds circuits or load.
Common reasons to call
A few signs this service may fit the home or project.
A policy renewal, a new policy, or a home purchase often brings questions about knob and tube or aluminum wiring.
In basements and attics, knob and tube shows up as single wires running along porcelain knobs and through porcelain tubes in the joists.
Aluminum wiring is dull silver at outlet and switch terminals, and the cable jacket is often marked AL or ALUMINUM.
Process
A simple process keeps the job clear from first review to final testing.
The basement, attic, panel, and a sample of outlets and fixtures are checked to see which circuits are still knob and tube or aluminum.
You get a room-by-room plan and quote, and the ESA notification is filed before work starts.
New wiring is fished in, the old circuits are disconnected, and ESA inspects the work so you have the paperwork for your insurer.
Careful in older homes
One customer rewiring a 130-year-old house noted very few holes in the plaster walls, a first pass of patching on each one, and drop sheets laid over the furniture before work started.
FAQ
Practical answers about knob & tube replacement.
Some insurers will cover a home with knob and tube after an inspection, and others require it to be replaced first. Ask your insurer what they need, and the work can be quoted to match.
No. In most homes, new wiring is fished through the existing walls and ceilings through small access holes, often working from the basement and attic.
Usually, yes. The work is done in stages, so most of the house keeps power while each section is rewired.
The risk is mainly at the connections, where aluminum wire can loosen and overheat over time. The fix is either replacing the circuits or repairing each connection with connectors approved for aluminum.
Yes. Rewiring needs an ESA notification and inspection. As a licensed electrical contractor (ECRA/ESA #7000346), Croatian Electric files it and books the inspection.
It depends on how much knob and tube or aluminum wiring is still in use. Some homes have only a few original circuits left, which keeps the job smaller.
Request service
Send the address, photos, and job details so Croatian Electric can review the electrical work needed.